Substantiation of selection of components at creation of thermal insulating dry building mixtures

  • Authors

    • V. I. Loganina Penza State University of Architecture and Construction
    • M. V. Frolov Penza State University of Architecture and Construction
    • Yu. P. Skachkov 3Penza State University of Architecture and Construction
    2018-11-14
    https://doi.org/10.14419/ijet.v7i4.10393
  • Heat-Insulating Dry Construction Mixtures, Fillers, Activity, Thermal Conductivity Coefficient, Packing Density.

  • Abstract

    The possibility of reducing the thermal conductivity of heat-insulating finishing coatings using as a filler ash microspheres of aluminosilicate and glass hollow microspheres is substantiated. A mechanism of heat transfer through heat-insulating composites is considered, depending on the type of filler used. It is revealed that the ability of the finishing coat to reflect heat does not depend on the type of filler used. It is established that the convective component of heat transfer does not significantly influence the heat-shielding qualities of the finishing coatings under consideration.

     

  • References

    1. [1] Trofimov B.Ya , Akhtyamov R.Ya., Ahmedyanov R.M., “Heat-insulating plastering solutions with vermiculite fillerâ€, Cement and its application, â„– 6, (2002),pp. 16-19.

      [2] Akhtyamov R.Ya, Ahmedyanov R.Ya, Trofimov B.Ya., “Light building plasters with vermiculite fillerâ€. Building materials, equipment, technologies of the XXI century, â„– 11, (2002), pp. 16-17.

      [3] Lesovik V.S., Zagorodnyuk L.Kh, Belikov D.A., Schekina A.Yu., Kuprina A.A., “Effective dry mixes for repair and restoration works†Building materials, № 7,(2014), pp. 82-85.

      [4] Natsievsky S.Yu., Alekseeva L.V., “Production of dry building mixtures using expanded perliteâ€, Dry building mixtures, â„– 6, (2012), pp. 26-27.

      [5] Semenov V.S, Rozovskaya T.A., “Increase in energy efficiency of enclosing structures using lightweight mortar solutions†, Building Materials, № 6, (2015), pp. 16-19.

      [6] Semenov V.S., Rozovskaya T.A., Oreshkin D.V., Energy-efficient dry mixes based on hollow microspheres, Cb. sci. work. III (XII) All-Russian (International) Conference "Concrete and reinforced concrete - a look into the future", Moscow, MGSU, (2014), pp. 344-352.

      [7] Kretova U.E., “Innovative filler for cement systems - ceramic microspheres “, Vestnik MGSU, №4, (2010), pp. 37-39.

      [8] Pashkevich A.A., Effective cement plastering solutions with hollow glass microspheres: the thesis of a Cand.Tech.Sci .: 05.23.05, Moscow, (2009),141

      [9] Kornienko S.V., Vatin N.I, Petrichenko M.R., Gorshkov A.S., “Evaluation of the moisture regime of a multilayer wall structure in the annual cycle “, Construction of unique buildings and structures, № 6,(2015), pp.19-33.

      [10] Vatin V.I., Gorshkov A.S., Glumov A.V., “Influence of physico-technical and geometric characteristics of plaster coatings on the moisture regime of homogeneous walls from aerated concrete blocksâ€, Engineering and construction magazine, â„– 1, (2011), pp. 28-33.

      [11] Loganina V.I., Frolov M.V., “Use of ash aluminosilicate microspheres in calcareous dry construction mixtures for finishingâ€, Herald of BSTU named after. V.G. Shukhov, â„– 3, (2017) pp.6-9

      [12] Loganina V.I., Frolov M. V., Skachkov Yu. P., “Lime composition for the walls of buildings made of aerated concreteâ€, Advances in Engineering Research, Vol. 93, (2016), pp.165-169

      [13] Loganina V.I, Frolov M.V. and Makridin N.I., “Thermal Insulation Lime Compounds for Walls of Aerated Concrete†, International Journal of Applied Engineering Research, Vol. 11, Number 18, (2016), pp. 9443-9445

      [14] Loganina V.I, Pyshkina I.S, Martyashin G.V., “Effect of the supplement based on calcium hydrosilicates on the resistance of lime coatingsâ€, Magazine of Civil Engineering, No. 4, (2017), pp. 20–27.

      [15] Protasiewicz A.M., Building thermophysics of enclosing structures of buildings and structures, Moscow, Ed. The Higher School, (2015), 240.

      [16] Dyakonov V.G., Lonshchakov O.A. Basis of heat transfer. Ed. Kazan National Research Technological University, 2011. 230 p.

      [17] Kudinov I.V., Stefanyuk E.V., Theoretical foundations of heat engineering. Part II. Mathematical modeling of thermal conductivity in multilayer enclosing structures. Ed. Samara State University of Architecture and Civil Engineering, EBS ASV, (2013). 422 p.

      [18] Litovsky E.Ya., Puchkevich N.A.. Thermophysical properties of refractories: Reference edition M .: Izd. Metallurgy. (1982),150

      [19] Rakhimbayev Sh.M., Т.V. Anikanova Т.V., “Theoretical aspects of improving the thermal characteristics of porous systemsâ€, Building Materials, â„– 4, (2007), pp. 26-28.

      [20] GOST R ISO 18434-1-2013 Condition monitoring and diagnostics of machines. Thermography. Part 1. General methods. Moscow: Izd. Standartinform 39 p.

      [21] Sagradyan A.A., Zimakova G.A., “Investigation of pozzolanic activity of ash microspheresâ€, Izvestiya. Institutions of higher education. "Construction", â„– 2, (2012), pp. 43-47.

      [22] Inozemtsev A.V, Korolev E.V., “Hollow microspheres - an effective filler for high-strength lightweight concreteâ€, Industrial and civil construction, â„– 10, (2013), pp. 80-83.

      [23] Bobryshev A.N., Zubarev P.A., Kuvshinov P.I., Lakhno A.V., “Analysis of the distribution of filler in the structure of compositesâ€, Internet-Bulletin VolgGASU. Ser.: Polythematical, â„– 1 (20) (2012).

  • Downloads

  • How to Cite

    I. Loganina, V., V. Frolov, M., & P. Skachkov, Y. (2018). Substantiation of selection of components at creation of thermal insulating dry building mixtures. International Journal of Engineering & Technology, 7(4), 4341-4344. https://doi.org/10.14419/ijet.v7i4.10393

    Received date: 2018-03-21

    Accepted date: 2018-04-04

    Published date: 2018-11-14