Design and Analysis of a Plate Heat Exchanger in the View of Performance Improvement and Cost Reduction

 
 
 
  • Abstract
  • Keywords
  • References
  • PDF
  • Abstract


    Redesigning of a system is a modification of existing system for reducing the disadvantages over the system and improves the features for getting more output that are desired. For redesigning the existing conventional heat exchanger by the new designed heat exchanger. Conventional heat exchanger has a major disadvantage consuming more space, high cost and maintenance is difficult. Plate heat exchanger has a major advantage over a conventional heat exchanger are that the liquid are exposed to main larger surface area because the liquids spread out over the plate. It is a specialized design well suited to transferring heat between low pressure liquids. The plate produces an extremely large surface area which allows for the fasten possible transfer and studying the plate material, gasket material, chevron angle, and surface enlargement angle. Design a plate heat exchanger by according more advantages and evaluate the cost of newly designed heat exchanger and compared to existing heat exchangers and validate the designs by flow analysis.

     

     


  • Keywords


    Heat exchanger, performance improvement, materials, analysis, CATIA.

  • References


      [1] Arsenyeva OP, Tovazhnyansky LL, Kapustenko PO & Khavin GL, “Optimal design of plate-and-frame heat exchangers for efficient heat recovery in process industries”, Energy, Vol.36, No.8,(2011), pp.4588-4598.

      [2] Naik VR & Natawala VK, “Experimental Investigation of Single Phase Chevron Type Gasket Plate Heat exchanger”, International Journal of Advanced Engineering Research and Studies, Vol.2, No. 4, (2013), pp.361–369.

      [3] Jogi Nikhil G & Lawankar Shailenda M, “Heat Transfer Analysis of Corrugated Plate Heat Exchanger of Different Plate Geometry: A Review’ Chemical Engineering Science”, The International Journal of Emerging Technology and Advanced Engineering, Vol.2, No.10, (2012), pp.110–115.

      [4] Genic SB, Jacimovic BM, Mandic D & Petrovic D, “Experimental Determination of Fouling Factor on Plate Heat Exchanger in Distinct Heating System”, International Journal of Advanced Engineering Research and Studies, (2012), pp.204–211.

      [5] Jin Z, Park G, Lee Y, Choi S, Chung H & Jeong H, “Design and Performance of Flow Distribution to the Channel in Plate Heat Exchanger”, International Conference on Engineering Optimization, (2008).

      [6] Durmus A, Benli H, Kurtbas I & Gul H, “Investigation of Heat Transfer in Plate Heat Exchangers Having Different Surface Profiles”, International Journal of Heat and Mass Transfer, Vol.52, (2009), pp.1451–1457.

      [7] Kukulka DJ & Devgun M, “Fluid Temperature and Velocity Effect on Fouling”, Applied Thermal Engineering, Vol.27, (2007).

      [8] Pignotti A & Tamborenia PI, “Thermal Effectiveness of Multi Passes Plate Exchangers”, International Journal of Heat and Mass Transfer, Vol.31, No.10, (1988), pp.1983-1991.

      [9] Wright AD & Heggs PJ, “Rating Calculation for Plate Heat Exchanger Effectiveness and Pressure Drop Using Existing Performance Data”, Transactions of IChem E, Vol.80, (2002), pp.309-312.

      [10] Z Yesembayeva (2018). Features of the legal status of judges: Kazakhstan experience and foreign realities Opción, Año 33. 447-474


 

View

Download

Article ID: 17994
 
DOI: 10.14419/ijet.v7i3.27.17994




Copyright © 2012-2015 Science Publishing Corporation Inc. All rights reserved.