Effects of Pin Diameter and Welding Position of Micro Friction Stir Spot Welding to the Mechanical Properties on Longitudinal Square Honeycomb Corrugated Panels

 
 
 
  • Abstract
  • Keywords
  • References
  • PDF
  • Abstract


    Weld aluminum material especially on thin plate is difficult because it cannot withstand the heat due to welding. Friction stir spot welding which is a solid state welding can overcome this damage because it does not require high temperatures. Then this technology is applied to the manufacture of lightweight structures square longitudinally corrugated honeycomb core sandwich panel product. This study is to determine how the pin diameter and welding position at straight and zig-zag position to the strength of the product. From the results, it is shown that diameter of the pin directly proportional to the strength of shear load. And in bending test, weld spot is an area that is weaker than the other area.

     

     

  • Keywords


    Micro Friction Stir Spot Weldin; Mechanical Propertie; Longitudinal Square Honeycomb Corrugated Panels

  • References


      [1] Crupi, V., et al., Theoretical and experimental analysis for the impact response of glass fibre reinforced aluminum honeycomb sandwich for the impact response aluminum honeycomb, Journal of Sandwich Structures and Materials, 2016. p. 1-28.

      [2] Yu, B., et al., Graded square honeycomb as sandwich core for enhanced mechanical performance, Materials and Design, 2016. 89: p. 642-652.

      [3] Li, Y., et al., Analytical homogenization for in-plane shear, torsion and transverse shear of honeycomb core with skin and thickness effects, Composite Structures, 2016. 140: p. 453-462.

      [4] Niu, B., et al., Directional mechanical properties and wave propagation directionality of Kagome honeycomb structures, European Journal of Mechanics A/Solids, 2016. 57: p. 45-58.

      [5] Combescure, C., et al., Hierarchical honeycomb material design and optimization: Beyond linearized behavior, International Journal of Solids and Structures, 2017. 115: pp. 161-169.

      [6] Neville, R. M., et al., Transverse stiffness and strength of Kirigami zero-m PEEK honeycombs, Composite Structures, 2014. 114: p. 30-40.

      [7] Baskoro, A. S., et al., Effects of micro resistance spot welding parameters on the quality of weld joints on aluminum thin plate AA 1100, International Journal of Technology, 2017. 7: p. 1306-1313.

      [8] Baskoro, A. S., et al., Effects of high speed tool rotation in micro friction stir spot welding of aluminum A1100, Applied Mechanics and Materials, 2014. 493: p. 739-742.

      [9] ASTM, C393/C393M-16: Standard test method for core shear properties of sandwich constructions by beam flexure.

      [10] ASTM, ASTM C273/C273M-16: Standard test method for shear properties of sandwich core materials.


 

View

Download

Article ID: 18898
 
DOI: 10.14419/ijet.v7i3.7.18898




Copyright © 2012-2015 Science Publishing Corporation Inc. All rights reserved.