Design of a Closed Air Open Water Humidification Dehumidification Desalination System

  • Authors

    • Haresh S Bhardwaj
    • Sreenath A R
    • Ranjitha Raj P
    • Jayakumar J S
    • Sreekumar P C
    • Balakrishnan Shankar
    https://doi.org/10.14419/ijet.v7i3.7.18903
  • CAOW, Carrier gas, Desalination, Sparger.
  • Desalination is the processes used to generate pure water from seawater. Humidification-Dehumidification (HDH) desalination is a low temperature thermal desalination process where the required thermal energy can be obtained from low quality sources. This paper details the design, analysis and fabrication of a Closed Air Open Water (CAOW), Saline Water Heated HDH equipment, capable of producing 50 litres of water in 6 hours. The main components, i.e. the humidifier, water heating chamber and dehumidifier were constructed from SS 3048 in order to resist corrosion. Multiple designs for sparger were considered, and keeping in mind the pressure drop experienced by the air, spider type spargers were chosen.  The equipment is capable of studying the effect of operating parameters, such as liquid column height, superficial gas velocity, etc. on dehumidifier and humidifier effectiveness.  It is also proposed to use different carrier gases in place of air, and a mechanism consisting of multiple valve-pipe arrangement was designed and fabricated in order to facilitate removal and filling of carrier gas in the equipment.

     

     

  • References

    1. [1] G. Prakash Narayan et al., The potential of solar-driven humidification- dehumidification desalination for small-scale decentralized water production, Renewable and Sustainable Energy Reviews 14.4 (2010): 1187-1201.

      [2] G. Prakash Narayan et al., Thermodynamic analysis of humidification dehumidification desalination cycles, Desalination and Water Treatment, 16:1-3, 339-353

      [3] G. Prakash Narayan et al., Entropy generation minimization of combined heat and mass transfer devices, International Journal of Thermal Sciences 49 (2010) 2057-2066

      [4] Kiyomi Akita and Fumitake Yoshida, Gas Holdup and Volumetric Mass Transfer Coefficient in Bubble Columns. Effects of liquid properties, Industrial & Engineering Chemistry Process Design and Development 1973 12 (1), 76-80

      [5] Peter Zehner and Matthias Kraume, Bubble Columns, Ullmann's Encyclopedia of Industrial Chemistry, 2000

      [6] A.V.Kulkarni, Design of a Pipe/Ring Type of Sparger for a Bubble Column Reactor, Chem. Eng. Technol., 33: 1015–1022

      [7] Kiyomi Akita and Fumitake Yoshida, Bubble Size, Interfacial Area, and Liquid-Phase Mass Transfer Coefficient in Bubble Columns, Ind. Eng. Chem. Process Des. Dev., 1974, 13 (1)

      [8] Y.T. Shah et al., Design parameters estimations for bubble column reactors, AIChE J., 28: 353–379

      [9] A.V.Kulkarni & Jyeshtharaj B. Joshi, Design and selection of sparger for bubble column reactor. Part I: Performance of different spargers, Chemical Engineering Research and Design Volume 89, Issue 10, October 2011, Pages 1972–1985

      [10] Mousa K. Abu Arabi & Kandi Venkat Reddy, “Performance evaluation of desalination processes based on the humidification/dehumidification cycle with different carrier gasesâ€, Desalination 156 (2003) 28 l-293

  • Downloads

  • How to Cite

    S Bhardwaj, H., A R, S., Raj P, R., J S, J., P C, S., & Shankar, B. (2018). Design of a Closed Air Open Water Humidification Dehumidification Desalination System. International Journal of Engineering & Technology, 7(3.7), 448-451. https://doi.org/10.14419/ijet.v7i3.7.18903