Torque and pitch control for wind energy conversion system using sliding mode approach

  • Authors

    • C Subba Rami Reddy
    • Pedda Suresh Ogeti
    • D Gireesh Kumar
    • N Bhoopal
    https://doi.org/10.14419/ijet.v7i3.29.19179
  • DFIG, Pitch Control, SMC, Torque Control, WECS.

  • Abstract

    The integration of wind energy with the grid is one of the major challenges as the wind energy depends upon the most fluctuating wind speeds. Therefore it requires a stringent methodology to control and maintain the stability of power system. This paper presents the torque and pitch control of Wind Energy Conversion System (WECS) that implements the variable speed Doubly Fed Induction Generator (DFIG) using Sliding Mode (SM) approach. For the speeds above the rated wind velocity, pitch control technique has been implemented and below the base speed torque control technique has been applied. The limitations of pitch actuator are compensated by the torque control of induction generator. The modeling and simulation of WECS with sliding mode control (SMC) scheme is carried out using MATLAB SIMULINK environment. The performance parameters such as pitch angle, active power, reactive power and rotor speed are compared for the Proportional plus Integral (PI), Linear Parameter Varying (LPV) and SMC schemes. Simulation results confirm that the performance of SM control is superior in terms of pitch, speed, active and reactive power compared to PI and LPV controllers.

     

     

  • References

    1. [1] Y. Z. F. Lescher and P. Borne, “Robust gain scheduling controller for pitch regulated variable speed wind turbine,†Stud. Inform. Control, vol. 14, no. 12, pp. 299–315, 2005.

      [2] R. M. F. Bianchi and C. Christiansen, “Gain scheduling control of variable speed wind energy conversion systems using quasi-PV models,†Control Engg. Practice, vol. 13, no. 2, pp. 247–255, 2005.

      [3] D. Leith and W. Leithead, “Appropriate realisation of gain-scheduled controllers with application to wind turbine regulation,†Int. J. Control, vol. 65, no. 2, pp. 223–248, 2005.

      [4] B. K. Stol, B. Rigney, “Accommodating control of a variable-speed turbine using a symbolic dynamics structural model,†Proc. 2000 ASME Wind Energy Symp.

      [5] J. W. X.Y. Zhang and J.-M. Yang, “H-infinity robust control of constant power out- put for the wind energy conversion system above rated wind,†Control Theory and Application, vol. 25, no. 2, pp. 321–324, 2008.

      [6] D. W. M. Soliman, O.P. Malik, “Multiple model multiple-input multiple-output predictive control for variable speed variable pitch wind energy conversion systems,†IET Renew. Power Gener., vol. 5, no. 2, p. 124136, 2011.

      [7] H. D. B. Fernando A. Inthamoussou, Fernando D. Bianchi and R. J. Mantz, “LPV wind turbine control with anti-windup features covering the complete wind speed range,†IEEE Trans. on Energy Conversion, vol. 29, no. 1, pp. 259–266, 2014.

      [8] A.U. Endusa Billy Muhando, Tomonobu Senjyu and T. Funabashi, “Gain-scheduled H∞ control for WECS via LMI techniques and parametrically dependent feedback part i: Model development fundamentals,†IEEE Trans. on Industrial Electronics, vol. 58, no. 1, pp. 48–56, 2011.

      [9] U. Endusa Billy Muhando, Tomonobu Senjyu and T. Funabashi, “Gain-scheduled H∞ control for WECS via LMI techniques and parametrically dependent feedback part ii: Controller design and implementation,†IEEE Trans. on Industrial Electronics, vol. 58, no. 1, pp. 57–65, 2011.

      [10] O. P. M. Mostafa Soliman, Member and D. T. Westwick, “Multiple model predictive control for wind turbines with doubly fed induction generators,†IEEE Trans on Sustainable Energy, vol. 2, no. 3, pp. 215–225, 2011.

      [11] T. D. Z. J. Can Huang, Fangxing Li and X. Ma, “Second-order cone programming-based optimal control strategy for wind energy conversion systems over complete operating regions,†IEEE Trans. on Sustainable Energy, vol. 6, no. 1, pp. 263–271, 2015.

      [12] S. Heier, Grid Integration of Wind Energy Conversion Systems. ISBN 0-97143-X: John Wiley and Sons Ltd, 1998.

      [13] Brice Beltran and M. E. H. Benbouzid, “Sliding mode power control of variable-speed wind energy conversion systems,†IEEE Trans. on Energy Conversion, vol. 23, no. 2, pp. 551–558, 2008.

      [14] Brice Beltran, Tarek Ahmed-Ali and M. E. H. Benbouzid, “High-order sliding control of variable speed wind turbines,†IEEE Trans. On Industrial Electronics, vol. 56, no. 9, pp. 3314–3321, 2009.

      [15] M. S.Chondrogiannis, “Stability of double fed induction generator under stator voltage oriented vector control,†IET Renewable Power Generation, vol. 2, no. 3, pp. 170–180, 2008.

      [16] G. T. L. X. Miren Itsaso Martinez, Ana Susperregui, “Sliding-mode control of a wind turbine-driven double-fed induction generator under non-ideal grid voltages,†IET Renewable Power Generation, vol. 7, no. 4, pp. 370–379, 2013.

  • Downloads

  • How to Cite

    Subba Rami Reddy, C., Suresh Ogeti, P., Gireesh Kumar, D., & Bhoopal, N. (2018). Torque and pitch control for wind energy conversion system using sliding mode approach. International Journal of Engineering & Technology, 7(3.29), 293-300. https://doi.org/10.14419/ijet.v7i3.29.19179

    Received date: 2018-09-07

    Accepted date: 2018-09-07