Hydraulic System with the Automatic Regulator of Liquid Flow and Investigation of its Operation

  • Authors

    • Farit D. Bairamov
    • Bulat F. Bairamov
    2018-09-27
    https://doi.org/10.14419/ijet.v7i4.7.20555
  • hydraulic system, hydraulic actuator, the liquid consumption regulation, dynamics equation, stability and accuracy of functioning.

  • Abstract

    Ensuring functioning of a hydraulic system requires the liquid consumption regulation given to the consumer. In hydraulic actuators by change of the liquid consumption regulation of the movement speed of an output link of the hydraulic engine is carried out: the movement speeds of the hydraulic cylinder piston or rotation frequency of a hydraulic motor shaft. In this work with the purpose of increase in efficiency of a hydraulic system and hydraulic actuators it is offered to use in them the most economical way of the liquid consumption regulation due to change of shaft rotation frequency of the pump engine. Schematic diagrams of a hydraulic system and hydraulic actuators with the automatic regulator of the liquid consumption are developed. For the drive of the pump the electric motor of alternating current is used. Shaft rotation frequency of the electric motor is regulated by the frequency converter.

    The linearized equations of dynamics of separate links of a hydraulic system from which after an exception of some variables the equations of dynamics of system in general are received are worked out. All equations are written down in a dimensionless form in relative deviations from a nominal operating mode of system. By consideration of hydraulic actuators the equation of dynamics of the hydraulic engine is in addition considered: hydraulic motor or hydraulic cylinder. At the same time the equations of dynamics of the pipeline and the hydraulic engine are replaced with one equation describing dynamics of the integrated link "the pipeline + the hydraulic engine".

    The research of stability and accuracy of functioning of a hydraulic system and hydraulic actuators is conducted. Accuracy of functioning is understood as the requirement that deviations of a consumption of the given liquid from its calculated value remained in in advance set limits. Stability conditions are received on the basis of Rauss - Gurvitz criterion, and for the solution of a problem of accuracy of functioning the method of functions of Lyapunov is used. The results received in article can be used at design of various adjustable hydraulic systems and hydraulic actuators for the rational choice of values of the parameters providing stability and accuracy of their functioning.

     

  • References

    1. [1] T.S. Jagadevlah, R.T. Smith, "Generation schemes for wind power plants", paper presented in the 10th Intersociety Energy Conversion Engineering Conference (IECEC), Newark.: Delaware, August, 1975.

      [2] F.D. Bairamov, I.G. Mardamshin, "Investigation of operation of hydraulic systems with wind pumping units", Russian Aeronautics, vol. 51, No. 3, pp. 314-320, 2008.

      [3] Farit D. Bairamov, Bulat F. Bairamov, "About hybrid system stability with distributed and concentrated parameters", Helix, vol. 8, No. 1, pp. 2493-2498, 2018.

      [4] N.N. Ivashchenko, "Automatic control", M.: Mechanical engineering, 736 pages, 1978.

      [5] A.V. Lepeshkin, A.A. Mikhaylin, A.A. Sheypak, "Hydraulics and hydropneumatic actuator. In 2 parts. Part 2. Hydraulic machines and hydropneumatic actuator", M.: MGIU, 352 pages, 2005.

      [6] A.M. Abdullina, F.D. Bayramov, B.F. Bayramov, "A hydraulic actuator with the operated electric motor of the pump and a research of its dynamics", the Scientific and technical bulletin of the Volga region, No. 2, S. 65-68, 2014.

      [7] I.G. Malkin, "Theory of stability of the movement", M.: Science, 530 pages, 1966.

      [8] K. Peiffer, N. Rouche, "Liapunov’s second method applied to partial stability", J. de Mech., vol. 8, No. 2, pp. 323-334, 1969.

      [9] T. Yoshizawa, "Stability theory by Lyapunov’s second method", Tokyo: Math. Soc. Jap., 223 p., 1966.

      [10] F.D. Bayramov, B.F. Bayramov, N.S. Galimov, A.R. Fardeev, "Technological processes with the combined power food: mechanics, management, automation", Kazan: Publishing house of the Kazan university, 342 pages, 2016.

  • Downloads

  • How to Cite

    D. Bairamov, F., & F. Bairamov, B. (2018). Hydraulic System with the Automatic Regulator of Liquid Flow and Investigation of its Operation. International Journal of Engineering & Technology, 7(4.7), 235-240. https://doi.org/10.14419/ijet.v7i4.7.20555

    Received date: 2018-09-29

    Accepted date: 2018-09-29

    Published date: 2018-09-27