Grid Integrated Wind Energy Storage System for Linear and non-Linear Loads

  • Authors

    • Dr. K. Suresh
    • A. R. Vijay Babu
    • P. M. Venkatesh
    2018-11-27
    https://doi.org/10.14419/ijet.v7i4.24.21859
  • The proposed system also has boost converter, bidirectional DC-DC converter and inverter for grid and wind energy integration. The boost inverter/buck rectifier in this system is controlled by ANFIS controller is for better output, boost and bidirectional DC-DC converters are controlled by PID controller in closed loop. Overall operations are based on modes main controller speedgoat, which is control the system operation in different modes. Any variation happening in the input, storage and load parameters speedgoat changing the mode and operate the system is in effective way. This paper presents harnessing of maximum wind energy from natural resource whenever it’s available. The power electronic converters role is important In between sources and load. The load may be linear and non-linear in nature, so converters performance decides the efficiency of the system. Proper controller can switch the converter in the desired time and improve the system performance and stability. Many controllers are suggests to control the converter to get better performance in at output side.

  • References

    1. [1] J. W. Kolar, U. Drofenik, and F. C. Zach, “Vienna rectifier II—A novel single-stage high-frequency isolated three-phase PWM rectifier system,†IEEE Trans. Ind. Electron., vol. 46, no. 4 (1999), pp. 674–691.

      [2] D. De and V. Ramanarayanan, “A dc-to-three-phase-ac high-frequency link converter with compensation for nonlinear distortion,†IEEE Trans. Ind. Electron., vol. 57, no. 11(2000), pp. 3669–3677.

      [3] D. S. B. Weerasinghe, U. K. Madawala, D. J. Thrimawithana, and D. M. Vilathgamuwa, “A three-phase to single-phase matrix converter based bi-directional IPT system for charging electric vehicles,†in Proc. 2013 IEEE ECCE Asia Down under, (2013), pp. 1240–1245.

      [4] A.K. Singh, P. Das, and S. K. Panda, “A novel matrix based isolated three phase ac-dc converter with reduced switching losses,†in Proc. 2015 IEEE Appl. Power Electron. Conf. Expo., (2015), pp. 1875–1880.

      [5] M. Matsui, M. Nagai, M. Mochizuki, and A. Nabae, “High-frequency link dc/ac converter with suppressed voltage clamp circuits-naturally commutated phase angle control with self-turn-off devices,†IEEE Trans. Ind. Appl., vol. 32, no. 2,(1966) pp. 293–300.

      [6] S. Norrga, “Experimental study of a soft-switched isolated bidirectional ac-dc converter without auxiliary circuit,†IEEE Trans. Power Electron., vol. 21, no. 6, (2006) pp. 1580–1587.

      [7] S. Norrga, S. Meier, and S. Ostlund, “A three-phase soft-switched isolated ac/dc converter without auxiliary circuit,†IEEE Trans. Ind. Appl., vol. 44, no. 3, (2008), pp. 836–844.

      [8] Li, Y. Zhong, and D. Xu, “Soft-switching three-phase matrix based isolated ac-dc converter for dc distribution system,†in Proc. 2015 IEEE Energy Convers. Congr. Expo, (2015), pp. 6755–6761.

      [9] M. Amirabadi, J. Baek, and H. A. Toliyat, “Bidirectional soft-switching series ac-link inverter,†IEEE Trans. Ind. Appl., vol. 51, no. 3, (2015) pp. 2312– 2320.

      [10] Vijaybabu, A.R. Rajyalakshmi, V & Suresh, K, ‘Renewable Energy Integrated High Gain DC-DC Converter with Multilevel Inverter for Water Pumping’, Journal of Advanced Research in Dynamical and Control Systems (2017), PP. 173-190.

      [11] X. Yu, F. Jin, and M. Wang, “A novel soft-switching modulation scheme for isolated dc-to-three-phase-ac matrix-based converter using SIC device,†in Proc. (2016) IEEE Energy Convers. Congr. Expo.

      [12] A.R.Vijay Babu,Gorantla Srinivasa Rao, Panthalingal Manoj Kumar, “Modelling, Simulation and Analysis of Performance Characteristics of an Air Breathing â€, Journal of Advanced Research in Dynamical and Control Systems, Volume 9, Issue 1, (2017) pp. 293-304.

      [13] Suresh, K &Arulmozhiyal, R, ‘Design and implementation of bi-directional dc-dc converter for wind energy system’, Circuits and Systems, E-ISSN 2153-1285, P-ISSN 2153-1293, vol. 7, (2016) pp. 3705-3722.

      [14] Z. Miao and L. Fan, “Modeling and small signal analysis of a PMSG based wind generator with sensor less maximum power extraction,†in Proc. IEEE PES Gen. Meeting, Jul. (2012), pp. 1–8.

      [15] B. Bryant and M. K. Kazimierczuk, “Small-signal duty cycle to inductor current transfer function for boost PWM dc–dc converter in continuous conduction mode,†in Proc. IEEE ISCAS, Vancouver, BC, Canada, May 23–26, (2004), pp. 856–859.

  • Downloads

  • How to Cite

    Suresh, D. K., Babu, A. R. V., & Venkatesh, P. M. (2018). Grid Integrated Wind Energy Storage System for Linear and non-Linear Loads. International Journal of Engineering & Technology, 7(4.24), 76-79. https://doi.org/10.14419/ijet.v7i4.24.21859