Nanoscale Zinc Hydroxyapatite (ZnHA) Particles for Bone Tissue Engineering

  • Authors

    • Noorainol Faiz Noor Haris
    • Mardziah Che Murad
    • Nik Rozlin Nik Masdek
    2018-11-30
    https://doi.org/10.14419/ijet.v7i4.26.22144
  • Calcination, Chemical precipitation, Hydroxyapatite, Structural Properties, Zinc

  • Abstract

    The aim of this paper is to discuss the differences in the structural properties of pure hydroxyapatite (HA) and zinc hydroxyapatite (ZnHA) nanoparticles. In this current research, nanosized HA and ZnHA were synthesised via chemical precipitation method with the use of ammonium dihydrogen phosphate, calcium oxide, zinc nitrate and distilled water. The temperature during synthesis process was maintained at 90 0C while the mixture stirred vigorously. The powders were then dried in the oven and calcined in a conventional high temperature furnace at 700 0C with varied soaking time of 2 and 3 hours for comparison purposes. The synthesised HA and ZnHA powders were subsequently characterised for thermal behaviour, phase composition and morphology examination using the Thermogravimetric Analyser (TGA), X-ray diffraction (XRD) and Field Emission Scanning Electron Microscopy (FESEM), respectively. From the XRD analysis, it was observed that the crystallinity of pure HA and ZnHA powders greatly increase after the calcination process. This can be indicated by the higher and rising intensities of the three main HA peaks in the XRD patterns. Even though the effect of soaking time during calcination did not seem very prominent from the diffraction spectra, its effect on the particle size can be seen clearly from the FESEM images. On the other hand, FESEM evaluation also shows that both HA and ZnHA nanoparticles are spherical in shape with the former powders having bigger size of particles.

     

  • References

    1. [1] R. Florencio-silva, G. Rodrigues, E. Sasso-cerri, M. J. Simões, P. S. Cerri, and B. Cells. Biology of bone tissue: Structure, function, and factors that influence bone cells. Biomed Research International, vol. 2015, 2015.

      [2] M. Maas, U. Hess, and K. Rezwan. The contribution of rheology for designing hydroxyapatite biomaterials. Curr. Opin. Colloid Interface Sci., vol. 19, no. 6, pp. 585–593, 2014.

      [3] A. R. Amini, C. T. Laurencin, and S. P. Nukavarapu. Bone tissue engineering: Recent advances and challenges. Crit. Rev. Biomed. Eng., vol. 40, no. 5, pp. 363–408, 2012.

      [4] M. Prakasam, J. Locs, K. Salma-Ancane, D. Loca, A. Largeteau, and L. Berzina-Cimdina. Fabrication, properties and applications of dense hydroxyapatite: A review. J. Funct. Biomater., vol. 6, no. 4, pp. 1099–1140, 2015.

      [5] Z. Evis and T. J. Webster. Nanosize hydroxyapatite: doping with various ions. Adv. Appl. Ceram., vol. 110, no. 5, pp. 311–321, 2011.

      [6] P. Turon, L. del Valle, C. Alemán, and J. Puiggalí. Biodegradable and biocompatible systems based on hydroxyapatite nanoparticles. Appl. Sci., vol. 7, no. 1, p. 60, 2017.

      [7] E. Boanini, M. Gazzano, and A. Bigi. Ionic substitutions in calcium phosphates synthesized at low temperature. Acta Biomater., vol. 6, no. 6, pp. 1882–1894, 2010.

      [8] M. L. Popescu et al. Biocompatibility of hydroxyl-apatite thin films obtained by pulsed laser deposition. Rev. Adv. Mater. Sci., vol. 8, no. 2, pp. 164–169, 2004.

      [9] D. Norhidayu, I. Sopyan, and S. Ramesh. Development of zinc doped hydroxyapatite for bone implant applications. Int. Conf. Constr. Build. Technol. 2008, no. 24, pp. 257–270, 2008.

      [10] O. Victor, V. O. Ajibola, E. B. Agbaji, and A. A. Giwa. Synthesis of calcium hydroxyapatite nanocrystals using chemical precipitation technique: A Review. vol. 4, no. 1, pp. 39–54, 2015.

      [11] C. M. Mardziah, N. R. N. Masdek, K. M. Hyie and I. Sopyan. Physicochemical Characteristics of MgHA derived via wet precipitation method. Journal of Mechanical Engineering, vol. 13 (2), pp. 10-20, 2016.

      [12] W. Khoo, F. M. Nor, H. Ardhyananta, and D. Kurniawan. Preparation of natural hydroxyapatite from bovine femur bones using calcination at various temperatures. Procedia Manuf., vol. 2, no. February, pp. 196–201, 2015.

      [13] A. Chandrasekar, S. Sagadevan, and A. Dakshnamoorthy. Synthesis and characterization of nano-hydroxyapatite (n-HAP) using the wet chemical technique. Int. J. Phys. Sci., vol. 8, no. 32, pp. 1639–1645, 2013.

      [14] W. M. Lima et al. Effect of the calcination time of fish bones in the synthesis of hydroxyapatite. Materials Science Forum, vol. 498-499, pp. 600-605, 2005.

      [15] S. M. Latifi, M. H. Fathi and M. A. Golozar. Preparation and characterization of hydroxyapatite-silica composite nanopowders. International Journal of Modern Physics: Conference Series, vol. 5, pp. 630-637, 2012.

  • Downloads

  • How to Cite

    Faiz Noor Haris, N., Che Murad, M., & Rozlin Nik Masdek, N. (2018). Nanoscale Zinc Hydroxyapatite (ZnHA) Particles for Bone Tissue Engineering. International Journal of Engineering & Technology, 7(4.26), 89-92. https://doi.org/10.14419/ijet.v7i4.26.22144

    Received date: 2018-11-29

    Accepted date: 2018-11-29

    Published date: 2018-11-30