Fiber Communication System Based on FBG As Dispersion Compensator, Design And Experimental Setup

  • Abstract
  • Keywords
  • References
  • PDF
  • Abstract

    The technological progress in the means of transmission of information is very fast and it becomes necessary to obtain high speed in data transmission and high data rate. The developments in optical communication systems cover these needs, so the developments in these systems become an urgent need. However, despite all characteristics and advantages of optical communication systems, there is the dis-persion problem. In this research we will get rid of this problem in practice through the use of fiber Bragg grating connected to two separate and different wavelengths then connecting them to the Wavelength Division Multiplexing and send them to a distance of 3 Km then calculate the amount of dispersion in the signal with and without fiber Bragg grating and compare the results.


  • Keywords

    Fiber Bragg Gratings; Dispersion Compensation; Wavelength Division Multiplexing; Fiber Bragg Grating Applications.

  • References

      [1] Sharma V., and Kaur D., “Review on Multiplexing Techniques in Optical Communication Systems” European Scientific Journal, Vol.2 ISSN: 1857 – 7881, (2015), pp.88-94.

      [2] P1 G., and Thomas S., “Performance Analysis of Dispersion Compensation using FBG and DCF in WDM Systems”, International Journal of Advanced Research in Computer and Communication Engineering, Vol. 4, (2015),Issue 10.

      [3] Watanabe Sh., Kato T., Okabe R., Elschner R.; Ludwig R., and Schubert C., “ALL-Optical Data Frequency Multiplexing on single-wavelength carrier Light by Sequentially Provided Cross-Phase Modulation in Fiber.” IEEE journal of Selected Topics in Quantum Electronics, Vol. 18, No. 2, (2012), pp.577-584.

      [4] Arora O., and Garg A., “Impact of Fiber Bragg Grating as Dispersion Compensator on the Receiver Characteristics”, Global Journal of Researches in Engineering Electrical and Electronics Engineering, Vol.11, (2011), 19-23.

      [5] Hill K. and Meltz G., “Fiber Bragg grating technology: Fundamentals and overview,” J. Light w. Technol., vol. 15, no. 8 (1997), pp. 1263–1276, Erdogan T., “Fiber grating spectra,” J. Light w. Technol., vol. 15, no. 8, (1997), pp. 1277–1294.

      [6] Prasad B., Patra K., Barpanda K.,” Performance Analysis of Fiber Optical Communication using Fiber Bragg Grating as Dispersion Compensator”, International Journal of Advanced Research Electrical,Electronics and Instrumentation Engineering ,Vol. 5, (2016) Issue 4.

      [7] O’Flaherty F.J., Ghassemlooy Z., Mangat P., and Dowker K. “Temperature Characterization of Long-Period Gratings for Sensor Applications” Microwave & Optical Technology Letters, vol. 42, no. 5, (2004) pp. 402-405.

      [8] Jopson R. “Compensation of fiber chromatic dispersion by spectral inversion”, Electron. Lett, Vol.29, (1993) pp.576- 578.

      [9] Nishide K. “1.55 µm Single Mode Fibers with Large Chromatic Dispersion”, IEICE spring conference, C-575, (1989).

      [10] Wójcik, W., Kisała P., Yussupova P., Kussambayeva N., Kashaganova G. and Harasim D. , “Analysis of the Possibilities for Using a Uniform Bragg Grating in a Tunable Dispersion Compensator”, Intl Journal Of Electronics And Telecommunications, Vol. 61, No. 4, (2015) Pp. 381-387




Article ID: 24037
DOI: 10.14419/ijet.v7i4.24037

Copyright © 2012-2015 Science Publishing Corporation Inc. All rights reserved.