Design of Power Amplifier for UWB Radar

  • Authors

    • Viresh J. Dighe
    • Poornima Srivastava
    • Sreedevi Nair
    2018-12-19
    https://doi.org/10.14419/ijet.v7i4.41.24505
  • ADS, Power Amplifier, UWB

  • Abstract

    This paper discusses the design of the power amplifier for UWB Radar. The power amplifier design is one of the important aspect of the UWB Radar as it helps in increasing the transmission range. The impedance matching is done by stub matching. The design of the power amplifier is done by using ADS software. The design frequency for the power amplifier is 6 GHz. The reason for choosing 6 GHz as design frequency is less rain fade in the communication channel, the larger bandwidth available at cheaper price. The bandwidth of 1.5 GHz is chosen so as to satisfy the FCC requirement of bandwidth to be greater than or equal to 0.25 times of center frequency. The UWB technology is used in various applications such as through-wall detection, airport-surveillance, obstacle detection.

     

     

  • References

    1. [1] D. M. Pozar “Microwave Engineeringâ€, New Delhi, Wiley India, Pvt. Ltd. 2014

      [2] M. I Skolnik, “Introduction to Radar Systemsâ€, Mcgraw Hill Education (India) Pvt. Ltd., 2013.

      [3] Ravikumar S., Nagendra N, M. Kothari “ Design and Simulation of 4W RF Power Amplifier for LTE band 28†2017 International Conference on Intelligent Computing and Control. pp. 1-5

      [4] Mamoru Akimoto, Tokio Taga “Characteristics of Bidirectional Printed Dipole Antennaâ€. vol-1 1996 Proceedings Vehicular Technology Conference pp. 357-361

      [5] Ariunzaya Batgerel, Soon Young Eon, Laxmikant Minz, Joung Myoun Kim,Jae Ick Choi, “High Gain Bidirectional Microstrip Antenna†2011 International Conference on Ultra-Wideband (ICUWB) pp. 21-24.

      [6] Wang Yao, Wei Li, Zhiyong Luo, Junyan Ren “Noise Figure in UWB Systems†2007 International Conference on ASIC. Pp. 364-367

      [7] E.Levine, H. Matzner, “A Relatively Flat Dual-Horn Antenna†2017 International Conference on Microwaves, Antennas, Communication and Electronic Systems. pp. 1-4

      [8] H.Erl, J.W.Kolar, F.C.Zach, “Basic Considerations and topologies of switched mode assisted linear power amplifiers†vol.1 1996 Applied Electronics Conference and Exposition. pp. 207-213

      [9] Yuan Zhuang, Zhouxiang Fei, Anqi Chen, Yi Huang and Jiafeng Zhou “Distributed Matching Network Design for Broadband Power Amplifiers†2017 IEEE Electrical Design of Advanced Packaging and Systems Symposium. pp. 1-3

  • Downloads

  • How to Cite

    J. Dighe, V., Srivastava, P., & Nair, S. (2018). Design of Power Amplifier for UWB Radar. International Journal of Engineering & Technology, 7(4.41), 110-112. https://doi.org/10.14419/ijet.v7i4.41.24505

    Received date: 2018-12-21

    Accepted date: 2018-12-21

    Published date: 2018-12-19