Structural and Morphological Characterization of Sr0.6Ba0.4Ce0.9Ga0.1O3-Δ for Proton-Conducting Solid Oxide Fuel Cell Application

  • Authors

    • Nur Wardah Norman
    • Wan Nor Anasuhah Wan Yusoff
    • Abdullah Abdul Samat
    • Mahendra Rao Somalu
    • Andanastuti Muchtar
    2019-01-30
    https://doi.org/10.14419/ijet.v8i1.2.24893
  • Proton-conducting electrolyte, solid oxide fuel cell, specific density
  • Sr0.6Ba0.4Ce0.9Ga0.1O3-δ (SBCG) electrolyte pellet was prepared by glycine-nitrate method, in which the electrolyte powders and pellets were systematically characterized for their application to proton-conducting solid oxide fuel cells (SOFCs). Thermogravimetric analysis revealed that impurities were formed in the electrolyte powders at the temperature of 1000 °C. X-ray diffraction analysis showed that the powder calcined at 1000 °C produced an electrolyte with high purity. Scanning electron microscopy analysis indicated that the sintered SBCG pellet had a clear morphology and grain boundaries. Therefore, SBCG is a promising electrolyte for SOFC applications.

     

     

     
  • References

    1. [1] Li M, Ni M, Su F & Xia C (2014), Proton conducting intermediate-temperature solid oxide fuel cells using new perovskite type cathodes. J. Power Sources 260, 197–204.

      [2] Rahman HA, Muchtar A, Muhamad N & Abdullah H (2010), Komposit La1-xSrxCo1-yFeyO3-d (LSCF) sebagai bahan katod tahan lama bagi sel fuel oksida pejal bersuhu sederhana-rendah: ulasan kajian. J. Kejuruteraan 22, 1–9.

      [3] Singh B, Ghosh S, Aich S & Roy B (2017), Low temperature solid oxide electrolytes (LT-SOE): a review. J. Power Sources 339, 103–135.

      [4] Arpornwichanop A, Patcharavorachot Y & Assabumrungrat S (2010), Analysis of a proton-conducting SOFC with direct internal reforming. Chem. Eng. Sci. 65(1), 581–589.

      [5] Wang Y, Leung DYC, Xuan J & Wang H (2017), A review on unitized regenerative fuel cell technologies, part B: unitized regenerative alkaline fuel cell, solid oxide fuel cell, and microfluidic fuel cell. Renew. Sustain. Energy Rev. 75, 775–795.

      [6] Norby T & Magraso A (2015), On the development of proton ceramic fuel cells based on Ca-doped LaNbO4 as electrolyte. J. Power Sources 282, 28–33.

      [7] Liu Y, Guo Y, Ran R & Shao Z (2012), A new neodymium-doped BaZr0.8Y0.2O3−δ as potential electrolyte for proton-conducting solid oxide fuel cells. J. Memb. Sci. 415–416, 391–398.

      [8] Radojkovic A, Zunic M, Savic SM, Brankovic G & Brankovic Z (2013), Chemical stability and electrical properties of Nb doped BaCe0.9Y0.1O3-d as a high temperature proton conducting electrolyte for IT-SOFC. Ceram. Int. 39, 307–313.

      [9] Yoo Y & Lim N (2013), Performance and stability of proton conducting solid oxide fuel cells based on yttrium-doped barium cerate-zirconate thin-film electrolyte. J. Power Sources 229, 48–57.

      [10] Ding X, Ding L, Wang L, Zhu W, Hua G, Liu H, Gao Z & Yuan G (2017), Improved electrochemical activity and stability of LaNi0.6Fe0.4O3-δ cathodes achieved by an in-situ reaction. Electrochim. Acta 236, 378–383.

      [11] Osman N, Jani AM & Talib IA (2006), Synthesis of Yb-doped Ba(Ce,Zr)O3 ceramic powders by sol-gel method. Ionics (Kiel). 12, 379–384.

      [12] Dahl P, Haugsrud R, Lein H, Grande T, Norby T & Einarsrud MA (2007), Synthesis, densification and electrical properties of strontium cerate ceramics. J. Eur. Ceram. Soc. 27, 4461–4471.

      [13] Yuan A, Tian L, Xu W & Wang Y (2010), Al-doped spinel LiAl0.1Mn1.9O4 with improved high-rate cyclability in aqueous electrolyte. J. Power Sources 195(15), 5032–5038.

      [14] Lee KR, Tseng CJ, Chang JK, Hung IM, Lin JC & Lee SW (2013), Strontium doping effect on phase homogeneity and conductivity of Ba1−xSrxCe0.6Zr0.2Y0.2O3−δ proton-conducting oxides. Int. J. Hydrogen Energy 38(25), 11097–11103.

      [15] Choudhury B & Choudhury A (2013), Oxygen vacancy and dopant concentration dependent magnetic properties of Mn doped TiO2 nanoparticle. Curr. Appl. Phys. 13 (6), 1025–1031.

      [16] Samat AA, Somalu MR, Muchtar A & Osman N (2016), Preparation of lanthanum strontium cobalt oxide powder by a modified sol-gel method. Malaysian J. Anal. Sci. 20(6), 1458–1466.

      [17] Samat AA, Senari SM, Somalu MR, Muchtar A, Hassan OH & Osman N (2018), Heat treatment effect on the phase and morphology of NiO-BCZY prepared by an evaporation and decomposition of solution and suspension method. Sains Malaysiana 47(3), 589–594.

      [18] Hossain S, Abdalla A, Radenahmad N, Zakaria AKM, Zaini JH, Rahman S, Eriksson S, Irvine J & Azad A (2018), Highly dense and chemically stable proton conducting electrolyte sintered at 1200 °C. Int. J. Hydrogen Energy 43(2), 894–907.

  • Downloads

  • How to Cite

    Wardah Norman, N., Nor Anasuhah Wan Yusoff, W., Abdul Samat, A., Rao Somalu, M., & Muchtar, A. (2019). Structural and Morphological Characterization of Sr0.6Ba0.4Ce0.9Ga0.1O3-Δ for Proton-Conducting Solid Oxide Fuel Cell Application. International Journal of Engineering & Technology, 8(1.2), 153-156. https://doi.org/10.14419/ijet.v8i1.2.24893