Comparative Analysis of Thermal and Hydraulic Performance Of PHE and S&T Heat Exchanger During Pasteurization of Mango Juice Using Nano fluid.

  • Authors

    • Pankaj Kesari
    • Debashis Dey
    • Dr. Sikata Samantaray
    2018-12-13
    https://doi.org/10.14419/ijet.v7i4.39.25667
  • .

  • Abstract

    Food industries including dairy units, fruits and beverages industries are frequently exposed to thermal processing inside heat- exchangers. Today, the vital demands for any food and beverages industries are fluids having high heat transfer characteristics, low pumping power, easy cleaning surfaces and hygienic operations. In foodstuff process industries these necessities are often met by different heat exchanger typically, plate- heat exchanger and the shell & tube heat -exchanger  are widely used. A comparative study of performance of plate-heat exchanger (PHE) and shell & tube heat -exchanger  (S&T HE) using Al2O3/distilled water nanofluid during the thermal processing of mango juice is done. The heat exchanging fluids employed here are nanofluid acting as hot fluid and mango juice as cold fluid. The experiment is carried out at constant cold fluid inlet temperature i.e. 20°C with varying inlet temperature of hot fluids (50, 55, 60 and 65°C) and varying volume flow rates (4, 5, 6 and 7LPM) for three nanoparticle concentrations (0.1, 0.2 and 0.3% by weight). Experimental results confirms that the Plate-heat exchanger (PHE) have high heat flux increment which is twice that of shell & tube heat -exchanger  (S&T HE) with lower pressure drop. The S&T HE have higher pressure drop compared to the PHE i.e. 36 times at low flow rate and 40 times at higher volume flow rate The enhancement of Nu number in PHE is 39% than that of S&T HE.

  • References

    1. [1] Pantzali M. N., Kanaris A. G., Antoniadis K. D., Mouza A. A., Paras S. V., Investigating the efficacy of nanofluids as coolants in plate-heat exchangers (PHE), Chemical Engineering Science, 64 (14) (2009) 3290-3300.

      [2] Tiwari A. K., Ghosh P., Sarkar J., Performance comparison of the plate-heat exchanger using different nanofluids, Experimental Thermal and Fluid Science 49 (2013) 141–151.

      [3] Javadi F.S., Sadeghipour Saidur S., BoroumandJazi R., Rahmati G., B., Elias M.M., Sohel M.R., International Communications in Heat and Mass Transfer, 44 (2013) 58–63.

      [4] Halelfadl T. Mare S., Sow O., Estelle P., S. Duret, F. Bazantay, Comparison of the thermal performances of two nanofluids at low temperature in a plate-heat exchanger Experimental Thermal and Fluid Science 35 (8) (2011) 1535–1543.

      [5] B. Farajollahi, S. Gh. Etemad, M. Hojjat, Heat transfer of nanofluids in a shell & tube heat -exchanger , International Journal of Heat and Mass Transfer, 53 (2011) 12–17.

      [6] S. F. S. Namini, S. M. Jafari, A. M. Ziaifar, A .M. Rashidi, Evaluation of Nutritional and Physical Properties of Watermelon Juice during the Thermal Processing by Using Alumina Nano-fluid in a Shell & tube heat -exchanger , Nutrition and Food Sciences Research, 2 (4) (2015) 47-54.

      [7] Z. T. Tabari, and S. Z. Heris, Heat transfer performance of milk pasteurization plate heat exchanger using MWCNT/Water nanofluid, 36 (2015) 196-204.

      [8] H. B. Kim, C. C. Tadini, R. K. Singh, Heat transfer in a plate-heat exchanger during pasteurization of orange juice, Journal of Food Engineering, 42 (1999) 79-84.

      [9] R. A. F. Cabral, J. A. W. Gut, V. R. N. Telis, J. T-Romero, Non-newtonian flow and pressure drop of pineapple juice in a plate-heat exchanger, Braz. J. Chem. Eng. 27 (4) (2010)

      [10] C. C. Tadini, G. G. Badolato, B. M. N. L. Vieira, A. C. Marques, Study of the Heat Transfer of Liquid Foods using a Plate Exchanger, (2000).

      [11] S. Rozzi, R. Massini, G. Paciello, G. Pagliarini, S. Rainieri, A. Trifiro, Heat treatment of fluid foods in a shell & tube heat -exchanger : Comparison between smooth and helically corrugated wall tubes, Journal of Food Engineering 79 (2007) 249–254.

      [12] Z. Haddad, C. Abid, H.F. Oztop, A. Mataoui, A review on how the researchers prepare their nanofluids, Int. J. Therm. Sci. 76 (2014) 168-189.

      [13] M.-S. Liu, M.C.-C. Lin, C.Y. Tsai, C.-C. Wang, Enhancement of thermal conductivity with Cu for nanofluids using chemical reduction method, Int. J. Heat Mass Transfer 49 (17–18) (2006) 3028–3033.

      [14] J. Fan and L. Wang, Review of heat conduction in nanofluids, J. Heat Transf., 133 (2011) 040801.

      [15] K. khanafer, K. Vafai, A critical synthesis of thermophysical characteristics of nanofluids. Int. J. Heat Mass Transfer 54 (2011) 4410-4428.

      [16] A. Gundurao, Thermo-physical, and rheological properties of mango puree as influenced by soluble solids, temperature and high pressure treatment. Thesis Mc GiII University, (2005).

  • Downloads

  • How to Cite

    Kesari, P., Dey, D., & Sikata Samantaray, D. (2018). Comparative Analysis of Thermal and Hydraulic Performance Of PHE and S&T Heat Exchanger During Pasteurization of Mango Juice Using Nano fluid. International Journal of Engineering & Technology, 7(4.39), 615-619. https://doi.org/10.14419/ijet.v7i4.39.25667

    Received date: 2019-01-11

    Accepted date: 2019-01-11

    Published date: 2018-12-13