Rutile-phased Titanium Dioxide (TiO2) Microstructures by Hydrothermal Method for Dye-Sensitized Solar Cell (DSSC)

  • Authors

    • F. I. M. Fazli
    • H. M. Zaini
    • M. K. Ahmad
    • N. K. A. Hamed
    • N. Nafarizal
    • C. F. Soon
    • R. Sanudin
    • H. S. Aziz
    • M. H. Mamat
    • A. B. Suriani
    • M. Shimomura
    • K. Murakami
    2019-01-18
    https://doi.org/10.14419/ijet.v8i1.7.25957
  • DSSC, Hydrothermal, Microstructure, Titanium Butoxide, Titanium Dioxide

  • Abstract

    This paper presents rutile-phased titanium dioxide (TiO2) microstructures fabricated by hydrothermal synthesis for the application as a photoanode in DSSC. The amount of precursor, titanium (IV) butoxide (TBOT) was varied from 0.5 to 2 ml and the changes on the surface morphology, structural and electrical property as well as their performance in DSSC were evaluated by using FE-SEM, XRD, 4-point probeand solar simulator respectively. Since the amount of precursor is too low, no rods were able to grow from the FTO substrates used, but flower formations can be seen on sample with 2 ml of TBOT. The structural analysis revealed rutile spectra for all samples with the peaks gradually increased as the amount of precursor increased. The conductivity decreases as the film thickens with increasing precursor amount, while the resistivity and sheet resistance decreased as the amount increase; as rutile structure is known to have good electron mobility. The performance of the TiO2 films in DSSC was evaluated, and the sample with the best performance was found in the film with 2 ml TBOT precursor at 0.234 % with Jsc and Voc of 0.759 and 0.643 respectively. Increased TBOT precursor is concluded to increase the efficiency of DSSC but the limit is yet to be studied and further research will be needed.

     

  • References

    1. [1] S. Shafiee and E. Topal, “When will fossil fuel reserves be diminished?,†Energy Policy, vol. 37, no. 1, pp. 181–189, 2009.

      [2] D. Popov, “An option for solar thermal repowering of fossil fuel fired power plants,†Sol. Energy, vol. 85, no. 2, pp. 344–349, 2011.

      [3] M. Grätzel, “Conversion of sunlight to electric power by nanocrystalline dye-sensitized solar cells à¬,†vol. 164, pp. 3–14, 2004.

      [4] M. H. Bazargan, M. M. Byranvand, A. N. Kharat, and L. Fatholahi, “Natural pomegranate juice as photosensitizers for dye- sensitized solar cell ( DSSC ),†vol. 5, no. 4, pp. 360–362, 2011.

      [5] J. Gong, J. Liang, and K. Sumathy, “Review on dye-sensitized solar cells (DSSCs): Fundamental concepts and novel materials,†Renew. Sustain. Energy Rev., vol. 16, no. 8, pp. 5848–5860, 2012.

      [6] A. Hagfeldt, G. Boschloo, L. Sun, and L. Kloo, “Dye-sensitized solar cells,†Chemical, 2010.

      [7] Z. S. Wang, H. Kawauchi, T. Kashima, and H. Arakawa, “Significant influence of TiO2photoelectrode morphology on the energy conversion efficiency of N719 dye-sensitized solar cell,†Coord. Chem. Rev., vol. 248, no. 13–14, pp. 1381–1389, 2004.

      [8] D. Chen et al., “Mesoporous anatase TiO2 beads with high surface areas and controllable pore sizes: A superior candidate for high-performance dye-sensitized solar cells,†Adv. Mater., vol. 21, no. 21, pp. 2206–2210, 2009.

      [9] S. a M. Al-Bat’hi, I. Alaei, and I. Sopyan, “Natural photosensitizers for dye sensitized solar cells,†Int. J. Renew. Energy Res., vol. 3, no. 1, 2013.

      [10] J. Yang, C. Bark, K. Kim, and H. Choi, “Characteristics of the Dye-Sensitized Solar Cells Using TiO2 Nanotubes Treated with TiCl4,†Materials (Basel)., vol. 7, no. 5, pp. 3522–3532, 2014.

      [11] L. Meng, H. Chen, C. Li, and M. P. Dos Santos, “Preparation and characterization of dye-sensitized TiO2 nanorod solar cells,†Thin Solid Films, vol. 577, pp. 103–108, 2015.

      [12] T. Nikolay, L. Larina, O. Shevaleevskiy, and B. T. Ahn, “Electronic structure study of lightly Nb-doped TiO2 electrode for dye-sensitized solar cells,†Energy Environ. Sci., vol. 4, no. 4, p. 1480, 2011.

      [13] H. Yin, Y. Wada, T. Kitamura, and S. Kambe, “Hydrothermal synthesis of nanosized anatase and rutile TiO2 using amorphous phase TiO2,†J. Mater., 2001.

      [14] F. De Angelis, S. Fantacci, E. Mosconi, M. K. Nazeeruddin, and M. Grätzel, “Absorption Spectra and Excited State Energy Levels of the N719 Dye on TiO 2 in Dye-Sensitized Solar Cell Models,†J. Phys. Chem. C, vol. 115, no. 17, pp. 8825–8831, 2011.

      [15] G. Amin, M. H. Asif, A. Zainelabdin, S. Zaman, O. Nur, and M. Willander, “Influence of pH, precursor concentration, growth time, and temperature on the morphology of ZnO nanostructures grown by the hydrothermal method,†J. Nanomater., vol. 2011, 2011.

      [16] W. Zhou et al., “Control synthesis of rutile TiO2 microspheres, nanoflowers, nanotrees and nanobelts via acid-hydrothermal method and their optical properties,†CrystEngComm, vol. 13, no. 14, pp. 4557–4563, 2011.

      [17] K. J. Hwang, W. G. Shim, S. H. Jung, S. J. Yoo, and J. W. Lee, “Analysis of adsorption properties of N719 dye molecules on nanoporous TiO2surface for dye-sensitized solar cell,†Appl. Surf. Sci., vol. 256, no. 17, pp. 5428–5433, 2010.

      [18] D. A. H. Hanaor and C. C. Sorrell, “Review of the anatase to rutile phase transformation,†pp. 855–874, 2011.

      [19] W. Guo et al., “Rectangular Bunched Rutile TiO 2 Nanorod Arrays Grown on Carbon 2 Fiber for Dye-Sensitized Solar Cells.â€

  • Downloads

  • How to Cite

    I. M. Fazli, F., M. Zaini, H., K. Ahmad, M., K. A. Hamed, N., Nafarizal, N., F. Soon, C., Sanudin, R., S. Aziz, H., H. Mamat, M., B. Suriani, A., Shimomura, M., & Murakami, K. (2019). Rutile-phased Titanium Dioxide (TiO2) Microstructures by Hydrothermal Method for Dye-Sensitized Solar Cell (DSSC). International Journal of Engineering & Technology, 8(1.7), 62-67. https://doi.org/10.14419/ijet.v8i1.7.25957

    Received date: 2019-01-16

    Accepted date: 2019-01-16

    Published date: 2019-01-18