Synthesis and Evaluation of Novel Naphthenate Inhibitor Demulsifier from Fatty Hydrazide Derivatives

  • Authors

    • N. Borhan
    • A. Ramli
    • I. K. Salleh
    2019-12-24
    https://doi.org/10.14419/ijet.v7i4.14.27527
  • Demulsifier, EOR (Enhance Oil Recovery), Fatty Hydrazide, Naphthenate Inhibitor

  • Abstract

    The production of crude oil contained Alkaline-Surfactant-Polymer (ASP)-chemical enhance oil recovery (CEOR) has a significant detrimental effect on flow assurance mainly for formation of microemulsion which is thermally stable and difficult to break and separated into clean crude oil and water phase. Quality of clean crude oil for saleability is important through achievement of crude oil dehydration in terms of basic sediment and water (BS&W) specification less than 0.5%.  This paper outlines a case-study where stable microemulsions were formed following mixing of crude oil and ASP brine, requiring operationally intensive remediation. Finally, novel palm oil-derived fatty hydrazide Naphthenate Inhibitor (NI)-Demulsifier were synthesized, formulated and tested using dynamic laboratory tests using a multifunctional mini flow loop (MMFL). Under dynamic laboratory test, crude oil, prepared produced water and ASP were mixed under high shear at separator temperature and pressure. The NI-demulsifiers chemical injection was carried out after microemulsions were formed before the separator, representing a wellhead injection point and for a sufficient time to allow the microemulsion system to reach equilibrium. This work demonstrates the importance of considering the impact of ASP-EOR fluids on existing emulsion and using an appropriate laboratory technique to evaluate potential mitigating treatments for oil-water separation technology. The effects of temperature and water cut on microemulsion stability are shown and the NI-demulsifier demonstrated excellence in demulsifying and dehydration at minimal dosage.

     

     

  • References

    1. [1] Abdel-Raouf, M. E. S. (2012). Factors Affecting the Stability of Crude Oil Emulsions. In M. E.-S. Abdel-Raouf, Crude Oil Emulsions – Composition Stability and Characterization, InTech, 183-204.

      [2] Shehzad, F., Hussein, I. A., Kamal, M. S., Ahmad, W., Sultan, A. S., Nasser, M. S. (2017). Polymeric surfactants and emerging alternatives used in the demulsification of produced water: A Review. Polymer Reviews, 58, 63-101.

      [3] Rajak, V. K., Singh, I., Kumar, A., Mandal, A. (2016). Optimization of separation of oil from oil-in-water emulsion by demulsification using different demulsifiers. Petroleum Science and Technology, 34, 1026–1032.

      [4] Hirasaki, G. J., Miller, C. A., Raney, O. G., Poindexter, M. K., Nguyen, D. T., Hera, J. (2010). Separation of produced emulsions from surfactant enhanced oil recovery processes. Energy & Fuels, 25, 555–561

      [5] Oseghale, C. I., Akpabio, E. J., Udottong, G. (2012). Breaking of oil -water emulsion for the improvement of oil recovery operations in the niger delta oilfields. International Journal of Engineering and Technology, 2, 1854–1860.0

      [6] Grbović, L., Pavlović, K., Vasilijevic, B., Kuhajda, K., Popsavin, M., Milic, J., Ćirin-Novta, V. (2012). Fractionation of complex mixtures of naphthenic acids, their characterization and biological. Journal of the Serbian Chemical Society, 77, 147-157.

      [7] Dyer, S. J., Graham, G. M., Arnott, C. (2003). Naphthenate scale formation-examination of molecular controls in idealized system,†SPE Oilfield Scale Symposium, Aberdeen, UK, 1-13.

      [8] Molinier, V., Loriau, M., Lescoulié, S., Martin, B., Gingras, J. P., Passade-Boupat, N. (2016). Quantification of the tetraprotic acids content in oil prediction of naphthenate deposit risk. IPTC-18704-MS.

      [9] Kang, W. L.; Liu, Y.; Qi, B. Y.; Liao, G. Z.; Yang, Z. Y.; Hong, J. C. (2000). Interactions between alkali surfactant polymer and their effects on emulsion stability. Colloid. Surf. A 175, 243–247.

      [10] Wu, J., Xu, Y., Dabros, T., Hamza, H. (2003). Effect of demulsifier properties on destabilization of water-in-oil emulsion. Energy & Fuel, 17, 1554- 1559.

      [11] Zhang, Z., Xu, G. Y., Wang, F., Dong, S. L., Li, Y. M. (2004). Characterization and demulsification of poly (ethylene oxide)-block-poly (propylene oxide)-blockpoly(ethylene oxide) copolymers J. Colloid Interface Sci, 277, 464-470.

      [12] Atta, A. A., Al-Shafy, H. I., Mohamed, Z. M. (2011). Application of hydrophobically modified water-soluble polyacrylamide conjugated with poly(oxyethylene)-copoly (oxpropyleene) surfactant as emulsifier, Polym. Adv. Technol., 22, 1879-1887.

      [13] Borhan, N., Salleh, I., Ibrahim, J. M. B. M., Farrell, A. R., Nichols, D. A., Graham, G. M. (2016). Investigation of Naphthenates Crude Oil Types and Behaviour to Induce Soaps-Microemulsion and Soap-Fines Foam in Malaysian EOR Fields. In International Petroleum Technology Conference. IPTC-18948-MS

      [14] Mohammed M.A., Sorbie K.S. (2010). Thermodynamic modelling of calcium naphthenate formation: Model prediction and experimental results. Colloids & Surfaces A: Physicochem. Eng. Aspects, 369, 1-10.

  • Downloads

  • How to Cite

    Borhan, N., Ramli, A., & K. Salleh, I. (2019). Synthesis and Evaluation of Novel Naphthenate Inhibitor Demulsifier from Fatty Hydrazide Derivatives. International Journal of Engineering & Technology, 7(4.14), 191-195. https://doi.org/10.14419/ijet.v7i4.14.27527

    Received date: 2019-02-18

    Accepted date: 2019-02-18

    Published date: 2019-12-24