A study on the strength development of geopolymer concrete using fly ash

  • Authors

    • Ramesh Babu Chokkalingam ASSOCIATE PROFESSOR,KALASALINGAM UNIVERSITY, KRISHNANKOIL
    • Ganesan N ASSISTANT PROFESSOR
    2017-11-24
    https://doi.org/10.14419/ijet.v6i4.7761
  • Flyash, Geopolymer, Sodium Silicate, Sodium Hydroxide, Compression.

  • Abstract

    Cement consumption is increasing day by day due to the tremendous development in the infrastructure facilities. The production of one ton of cement emits approximately one ton of carbon dioxide to the atmosphere. In order to reduce the use of cement a new-generation concrete has been developed such as geopolymer concrete (GPC).Geopolymer Geopolymer is a new material which has the potential to replace ordinary Portland cement. It is an inorganic material synthesized by alkali activation of amorphous aluminosilicates at ambient or slightly increased temperatures having an amorphous to semi-crystalline polymeric structure. In this study, low calcium flyash from Tuticorin was used to produce geopolymer concrete. The geopolymer was synthesized with sodium silicate and sodium hydroxide solutions. The sodium hydroxide pellets was dissolved in the distilled water to make free from mixing water contaminants. The ratio of sodium silicate and sodium hydroxide ratio was kept as 2.5. The concentration of sodium hydroxide solution is 12 Molarity (12M). Other materials used are locally available coarse aggregate and fine sand in surface dry condition. A polycarboxlate HRWRA La Hypercrete S25was used. Cubes of size 100mm were cast for six mix proportions of 450kg/m3 flyash+0.35W/B, 500 kg/m3 flyash+0.35W/B, 550kg/m3 flyash+0.35W/B, 450kg/m3 flyash+.0.40 W/B, 500kg/m3 fly ash+0.40W/B and 550kg/m3 flyash+0.40W/B. The specimens after casting in moulds were kept in oven at 60°C for 6 hours and left to air dry at room temperature and tested at 7 and 28 days. The test results revealed the compressive strength of 30 Mpa was achieved. There was not much significant difference in strength development at 28 days between the mixes due to the increase of flyash content. The microstructural images at 28 days revealed that there was not much difference in the microstructure due to the variation in flyash content from 450 kg/m3 to 550 kg/m3.

  • References

    1. [1] MCG. Juenger, F. Winnefeld, J.L. Provis and J.H. Ideker, “Advances in alternative cementitious binders,†Cement and Concrete Research. vol. 41, pp. 1232–1243, 2010. https://doi.org/10.1016/j.cemconres.2010.11.012.

      [2] J. Davidovits, “Geopolymer chemistry and application,†2nd edition, Saint-Quentin (France); Institut Geopolymere; 2008.

      [3] Hardjito, Djwantoro and B. Vijaya Rangan, “ On the development of flyash based geoplymer concreteâ€, ACI Materials Journal, 101, pp. 467-472, 2004

      [4] Daniel L.Y. Kong, Jay G. Sanjayan, Effect of elevated temperatures on geo polymer paste, mortar and concrete, Cement and Concrete Research 40 (2010) 334- 339 https://doi.org/10.1016/j.cemconres.2009.10.017.

      [5] Benny Joseph, George Mathew, Influence of aggregate content on the behavior of fly ash based geopolymer concrete,Scientia Iranica A (2012) 19(5), 1188-1194 https://doi.org/10.1016/j.scient.2012.07.006.

      [6] Tawatchai Tho –in, Vanchai Sata, Pervious high calcium fly ash geopolymer concrete, Construction and Building Materials 30 (2012) 366 -371 https://doi.org/10.1016/j.conbuildmat.2011.12.028.

      [7] Gum Sung Ryu, Young Bok Lee, Kyung Taek Koh, oung Soo Chung, The mechanical properties of fly ash based geo polymer concrete with alkaline activators, Construction and Building Materials 47 (2013) 409-418 https://doi.org/10.1016/j.conbuildmat.2013.05.069.

      [8] Vanchai Sata, Ampol Wongsa, Prinya Chindaprasirt, Properties of pervious geopolymer concrete using recycled aggregates, Construction and Building materials 42 (2013) 33-39 https://doi.org/10.1016/j.conbuildmat.2012.12.046.

      [9] Prabir K. Sarkar, Rashedul Haque, Karamchand V. ramgolam Fracture behavior of heat cured fly ash based geopolymer concrete , Materials and Design 44 (2013) 580-586 https://doi.org/10.1016/j.matdes.2012.08.005.

      [10] Navid Ranjbar, Mehdi Mehrali, Compressive strength and micro structural analysis of fly ash/palm oil fuel ash based geopolymer mortar under elevated temperatures, Construction and Building Materials 65 (2014) 114 -121 https://doi.org/10.1016/j.conbuildmat.2014.04.064.

      [11] Pradip Nath, Prabir Kumar Sarkar, Effect of GGBFS on setting, workability and early strength properties of fly ash geopolymer concrete cured in ambient condition, Construction and Building materials 66 (2014) 163 -171 https://doi.org/10.1016/j.conbuildmat.2014.05.080.

      [12] Tianyu Xie, Togay Ozbakkaloglu, Behavior of low calcium fly ash and bottom ash based geopolymer concrete cured at ambient temperature, Ceramics International 41 (2015), 5945- 5958 https://doi.org/10.1016/j.ceramint.2015.01.031.

      [13] Rasoul Shadnia, Lianyang Zhang, Peiwen Li, Experimental study of geopolymer mortar with incorporated PCM, Construction and Building Materials 84 (2015) 95-102 https://doi.org/10.1016/j.conbuildmat.2015.03.066.

      [14] Moser R.D., Allison P.G, Williams B.A, Weiss Jr C.A, Diaz A.J, Gore E.R, Malone P.G, Improvement in the geopolymer-to-steel bond using a reactive vitreous enamel coating, Construction and Building Materials 49 (2013) 62- 69 https://doi.org/10.1016/j.conbuildmat.2013.08.001.

      [15] Chindaprasirt P, Chalee W, Effect of sodium hydroxide on chloride penetration and steel corrosion of fly ash based geopolymer concrete under marine site, Construction and Building Materials 63 (2014) 303-310 https://doi.org/10.1016/j.conbuildmat.2014.04.010.

      [16] Ganesan N, Ruby Abraham, Deepa Raj S, Divya Sasi, Stress-strain behavior of confined Geopolymer concrete, Construction and Building Materials 73 (2014) 326 – 331 https://doi.org/10.1016/j.conbuildmat.2014.09.092.

      [17] Part Wei Ken, Mahyuddin Ramli, Cheah Chee Ban, An overview on the influence of various factors on the properties of geopolymer concrete derived from industrial by-products, Construction and Building Materials 77 (2015) 370 -395 https://doi.org/10.1016/j.conbuildmat.2014.12.065.

      [18] Singh B, Ishwarya G, Gupta M, Bhattacharyya, Geopolymer concrete: A review of some recent developments, Construction and Building Materials 85 (2015) 78-90 https://doi.org/10.1016/j.conbuildmat.2015.03.036.

      [19] Wahid Ferdous, Allan manalo, Amar Khennane, Obada kayali, Geopolymer concrete- filled pultruded composite beams Concrete mix design and application, Cement & Concrete Composites 58 (2015) 1-13 https://doi.org/10.1016/j.cemconcomp.2014.12.012.

      [20] Mijarsh M.J.A, Megat Johari, Zainal Arifin Ahmad, Compressive strength of treated palm oil fuel ash based geopolymer mortar containing calcium hydroxide, aluminium hydroxide and silica fume as mineral additives, Cement & Concrete Composites 60 ( 2015) 65-81 https://doi.org/10.1016/j.cemconcomp.2015.02.007.

      [21] Habert G, d’Espinose de Lacaillerie J.B, Roussel N, An environmental evaluation of geopolymer based concrete production: reviewing current research trends, Journal of Cleaner Production 19 (2011) 1229 – 1238 https://doi.org/10.1016/j.jclepro.2011.03.012.

      [22] Prakash R. Vora, Urmil V.Dave, Parametric Studies on Compressive Strength of Geopolymer Concrete, Procedia Engineering 51 (2013) 210 – 219 https://doi.org/10.1016/j.proeng.2013.01.030.

      [23] Kolli Ramujee, Potharaju M, Abrasion Resistance of Geopolymer Composites, Procedia Materials Science 6 (2014),1961-1966.

      [24] Djwantoro Hardjito, Steenie E. Wallah, Dody M.J. Sumajouw and Vijaya Rangan B, On the development of Fly ash – Based Geopolymer Concrete, ACI Material Journal, November-December( 2004), 467- 472.

      [25] Khadiranaikar R.B, Shankar H. Sanni, Experimental Investigations of Reinforced Geopolymer Concrete Beams, ICI Journal /July- September (2016) 29-37.

      [26] Indian Standard Code of practice for Methods of test for strength of concrete IS: 516 – 1959, Bureau of Indian Standards, New Delhi.

      [27] Indian standard Code of practice for specifications for coarse and fine aggregates from natural sources for concrete IS: 383-1970, Bureau of Indian Standards, New Delhi.

      [28] Parthiban K., Saravanrajmohan K., Shobana S., and Anchal Bhaskar A., Effect of replacement of slag on the mechanical properties of flyash based geopolymer concrete, International Journal of Engineering and Technology, (2013), Vol5, No.3, 2555-2559.

  • Downloads

  • How to Cite

    Chokkalingam, R. B., & N, G. (2017). A study on the strength development of geopolymer concrete using fly ash. International Journal of Engineering & Technology, 6(4), 163-167. https://doi.org/10.14419/ijet.v6i4.7761

    Received date: 2017-05-11

    Accepted date: 2017-11-17

    Published date: 2017-11-24